How To Install Epson Stylus Nx420 Printer

Install Epson Stylus Nx420 Printer

To install Epson Stylus NX420 printer physically, Use the following procedure.

1. Unbox

  • Take out the printer from the carton and check if the printer accessories such as ink cartridges, power cord, installation CD, and user manuals, are present.
  • Take off the packaging tapes and all the protective materials from the outside and inside of the printer.

2. Power connection

  • Using the power cord, connect the printer and an electrical wall socket.
  • On the printer’s control panel, press the power button to switch on the printer.
  • After the display panel turns on, choose the language of your choice using the navigation keys, and select it by pressing Start.

3. Insert the ink cartridges

  • Raise the scanner unit and open the ink cartridge cover inside the printer.
  • Take an ink cartridge packet and gently shake it. Then, unpack the cartridge.
  • Peel off the thin yellow film from the cartridge; then insert the cartridge into its corresponding slot and press until it snaps in a position.
  • After that, close the ink cartridge cover and lower the scanner unit.
  • Now, press the Start button on the control panel to start the ink charging process.
  • Wait until the ink charging gets done. In the end the completion message appears on the printer’s display panel.

4. Feed paper 

  • Draw the paper support upwards and also, extend the extension upwards.
  • Slowly pull the paper output tray, then the extension, and unfold the paper stopper flap.
  • Move the paper edge guide to the left end and place the paper with the print side facing up and touching the right edge of the support.
  • Adjust the paper edge guide to the edge of the paper but make sure that the paper does not bend or cripple.

5. Software installation

  • After all the hardware setup is over, you have to install the printer software on the computer for easy printer management.
  • Download the Epson Stylus NX420 printer driver from the official Epson website, or else, insert the installation CD and run the installation.
  • During the installation, you can select the connection type and the software to be installed.
  • Complete the installation to set up the printer successfully.
  • Click the Call button provided on this web page to get remote assistance to Install Epson Stylus Nx420 Printer.